Starter Kit for TriCore TC1767

CPU Clock: 133 MHz
 
Including:

• TriBoard Hardware
• USB cable
• Power Supply
• Extension Board
• Getting Started, first 3 Steps to install the Tools, set up your Hardware, write and debug the first program
• Technical Documentation: e.g. User manuals (System unit and
  Peripheral unit), Architecture manual, Application notes, Data Sheets,
  Board Documentation (pdf-version)
• Evaluation Versions of Development Tools: e.g. Compiler, Debugger from Tool Partners 
  
  

On-Chip Memory:

• 2 MByte embedded program flash with ECC,
• 16KByte EEPROM (emulated by 64KByte data Flash),
• 92 KByte on-chip SRAM,
• 4KByte data cache,
• 8 KByte instruction cache.

Interfaces:

• One USB connector for ASC0 Interface via virtual COM port, JTAG (OCDS Level1)
• 16-pin header for JTAG interface (OCDS Level 1)
• 10-pin header for DAB
• 2 x 10pin (2x5) header for CAN High Speed Transceiver (CAN0 and CAN1)
• 2 x SUB-D9 Plug connector for FlexRay
• Four 80-pin connectors (male) + four 80-pin connectors (female) with all I/O signals
• ETK connector (optional)

Components:

• Infineon’s Next generation micro controller supply TLE 7368 G
• 2 x Infineon’s High Speed CAN-Transceiver TLE 6250 GV33
• USB to UART bridge FT2232D (FTDI)
• SPI EEPROM (Atmel)
• Infineon's FlexRay Communication Controller SAK-CIC310
• 2 x FlexRay Transceiver AS8221(AMS) or TJA1080 (NXP)
• Three LEDs to validate power supply (5Volt / 3,3 Volt / 1,5 Volt)
• LED indicating /HDRST (ESR0) active state
• LED indicating active miniWiggler
• LED switched via DAS software
• 8 general purpose LEDs
• Reset switch
• 8-pin Dip switch (Hardware Boot Configuration)