Starter Kit for TriCore TC1782

MCU Derivates: SAK-TC1782-320F180HL

CPU Clock: 180 MHz
 
Including: 

• TriBoard Hardware
• USB cable
• Power Supply
• Extension Board
• Getting Started, first 3 Steps to install the Tools, set up your Hardware, write and debug the first program
• Technical Documentation: e.g. User manuals (System
  unit and Peripheral unit), Architecture manual, Application notes, Data
  Sheets, Board Documentation (pdf-version)
• Evaluation Versions of Development Tools: e.g. Compiler, Debugger from Tool Partners

On-Chip Memory: 

• 2,5 MByte embedded program flash with ECC 
• 128 KByte data Flash 
• 176 KByte on-chip SRAM, 
• 4 KByte data cache (configurable) 
• 16 KByte instruction cache (configurable) 
  
  

Interfaces:

• One USB connector for ASC0 Interface via virtual COM port, JTAG (OCDS Level1) 
  
• 16-pin header for JTAG interface (OCDS Level 1) 
  
• 10-pin header for DAB 
  
• 2 x 10pin (2x5) header for CAN High Speed Transceiver (CAN0 and CAN1) 
  
• 2 x SUB-D9 Plug connector for FlexRay 
  
• Four 80-pin connectors (male) + four 80-pin connectors (female) with all I/O signals 
• ETK connector (optional) 
  
  

Components: 

• Infineon’s Next generation micro controller supply TLE 7368 G
• 2 x Infineon’s High Speed CAN-Transceiver TLE 6250 GV33
• USB to UART bridge FT2232D (FTDI)
• SPI EEPROM (Atmel)
• 2 x FlexRay Transceiver AS8221(AMS) or TJA1080 (NXP)
• Three LEDs to validate power supply (5Volt / 3,3 Volt / 1,5 Volt)
• LED indicating /HDRST (ESR0) active state
• LED indicating active miniWiggler
• LED switched via DAS software
• 8 general purpose LEDs
• Reset switch
• 8-pin Dip switch (Hardware Boot Configuration)

Find more information about the Starter Kit TC1782 at the Infineon Website.