Starter Kit for TriCore TC179x

Product information "Starter Kit for TriCore TC179x"

• TriBoard Hardware
• USB cable
• Extension Board
• Getting Started, first 3 Steps to install the Tools, set up your Hardware, write and debug the first program
• Technical Documentation: e.g. User manuals (System unit and Peripheral unit), Architecture manual, Application notes, Data Sheets, Board Documentation (pdf-version)
• Evaluation Versions of Development Tools: e.g. Compiler, Debugger from Tool Partners

• 2 MByte embedded program flash with ECC
• 128 KByte data flash for scalable 16 KByte EEPROM emulation
• 192 KByte on-chip SRAM
• 16 KByte instruction cache

• Burst FLASH up to 16 MBytes (default: 4 MBytes)
• asynchronous SRAM up to 1MBytes (default)
• optional synchronous SRAM up to 8 MBytes

• One USB connector for ASC0 Interface via virtual COM port, JTAG (OCDS Level1)
• 16-pin header for JTAG interface (OCDS Level 1)
• 2 x 10pin (2x5) header for CAN High Speed Transceiver (CAN0 and CAN1)
• Four 80-pin connectors (male) + four 80-pin connectors (female) with all I/O signals
• 2 x SUB-D9 Plug connector for FlexRay (optional)
• ETK connector (optional)

• Infineon’s Next generation micro controller supply TLE 7368 G
• Three LEDs to validate power supply (5Volt / 3,3 Volt / 1,5 Volt)
• 2 x Infineon’s High Speed CAN-Transceiver TLE 6250 GV33
• USB to UART bridge FT2232D (FTDI)
• SPI EEPROM (Atmel)
• LED indicating /HDRST (ESR0) active state
• LED indicating active miniWiggler
• LED switched via DAS software
• 8 general purpose LEDs
• Reset switch
• 8-pin Dip switch (Hardware Boot Configuration)
• Infineon’s FlexRay Communication Controller SAK-CIC310 (optional)
• 2 x FlexRay Transceiver AS8221(AMS) or TJA1080 (NXP) (optional)

Links to "Starter Kit for TriCore TC179x"

Customer reviews on "Starter Kit for TriCore TC179x"

Write a review

Your name*:

 

Your email address:*:

 

Summary*:

 

Rating*: 10 excellent 9 8 7 6 5 4 3 2 1 miserable

 

Your opinion

 

Please type in this number sequence in the upcoming input box

 

 

All boxes marked with * must be filled out